Static vs Dynamic

I ever try to make Autonomous small-scale in which there is a Static Routing and Routing Dimanic which I want to combine, in fact can not be connected between Dynamic Routing and Static Routing, week ago in the lab networking I get the answer, it appeared that the Router Dinamic (RIP) Default Routing give in and be the default-information originate.

Step normally do first configuration ethernet, serial and Routing, and then in router 2 (R2) input command as below:



R2(config)#ip route 0.0.0.0 0.0.0.0 192.168.5.0 255.255.255.0     
                      // This command is intended to router static
R2(config)#router rip
R2(config-router)#default-information originate

The command above is applied on the dynamic router directly connected with Router static routing